Logo

U2001 Engine Trouble Code

Meaning of U2001 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U2001 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U2001 code is occuring now you should check U2001 repair processes.
Now don't ask yourself; What should you do with U2001 code ?
The solution is here :

U2001 Possible Solution:

U2001 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U2001 Code Meaning :

U 2 0 0 1
OBD-II Diagnostic Network (U) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Ambient Air Temperature Sensor Circuit Low Cold Start Injector 1 Malfunction Crankshaft Position Sensor A Circuit Low Input

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U2001 OBD-II Diagnostic Network (U) Trouble Code Description

U2001 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For U2001 Code

The reason of U2001 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

U2001 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.